Contacts on the front for measuring and testing in both directions, Disconnection Module have two-piece
contacts normally closed, incorporating a disconnection facility.
Disconnection Module - IDC
Profile Module
The advantages of profile modules are to be found in the simple mounting, reliable contact-making and clear
layout. This db system minimizes the work required for jumpering
Switching Module - IDC
Normally open contact on the front for serial insertion of protection plugs and for measuring and testing.
Switching modules have two-piece contacts normally open to allow
connection by one of pole bridging plugs,
testing leads or patch cords.
FT Module
This FT (feed through) module is a two-piece assembly consisting of a base and a connector it allows highdensity termination in a small area, the design of this module provides a compact, faster installation. Simply terminate the cables, remove the connector, flip it over and you are ready for patching or jumpering.
Mounting Frame & Accessories - IDC
Label Holder for Connection Module
This FT (feed through) module is a two-piece assembly consisting of a base and a connector it allows highdensity termination in a small area, the design of this module provides a compact, faster installation. Simply terminate the cables, remove the connector, flip it over and you are ready for patching or jumpering.
Protection Unit & Magazine for Disconnection Module
Specially designed in single unit for protecting lines of them burns out, it is easily replaceable without any
disturbance to other protectors and lines. Wherever there is an over voltage on the line due to lightning strike,
the protection unit will clamp down the voltage immediately.